b'AAC VINTAGE-WARRIORVintage-Warrior Quick-Tune Watts Link System:o1.00 OD Triangulated Chromoly Watts Link Framework KitoYou TIG Weld It & the 1-3/8 Chromoly Chassis Structure into The Clip o5 6061-T6 Bellcrank w/Thick Clevises & Dual HD Roller BearingsTrunk oTriangulated 4130 Chromoly Triangulated Driver Side MountExtension oPassenger Side Link Attaches on the XHD Lower Axle MountRod & o1 OD x .065 4130 Tubes Tig Welded with 5/8 Threaded Tube EndsCone o5/8 x 1/2 Wide Body, Chromoly Rod Ends, Rated for 31,000# LoadIncluded oNylatron Matrix Liner (Similar to Kevlar) 1# Stiction & Self Lubricatingo1/2"-NF & 5/8-NF 170,000 KSI 12-Point Bolts & AN HardwareOption:Watts Framework TIG Welded Into Rear Clip$750 The Key is the Trick Billet Steel Adjuster with Jack Screw: oAdjuster Cone Mounts on Top with an Extension Rod Into Trunk oJack Screw Adjuster Offers 6 of Marked Roll Center Tuning Range! oWith a 1/2" Ratchet, You Can Tune Your Rear Roll Center Height to Balance the Handling of Your Race Carin Seconds, Not Minutes oIf the Track is Low-Gripand Your Car is Free (Rotates Too Easily) or Loose (Oversteer)Simply Adjust Your Rear Roll Center Down to Shift Grip from the Front to the RearoIf the Track is High-Gripand Your Car is Tight (Hard to Turn) or Pushing (Understeer)Simply Adjust Your Rear Roll Center Up to Shift Grip from the Rear to the FrontoQuickest, Easiest, Most Accurate & PRECISE Rear Roll Center Tuning oHalf a Turn is .035 !!!3-1/2 Turns is 1/4" / Precise Tuning is Easy Peasy ! Build Tip: Ideally you would install the clips & build your car of a flat surface table.But its not necessary, just easier. No floors are level, so you need to take the time to elevate the car on solid stands & shim them until the car is level both ways. Then do the same with both front & rear frame clips. Once level, check & adjust clip squareness to each other & the wheelbase. When all good, tack weld the clips to the car & 2x3 subframe connectors.Final check squareness, level & wheelbase, then weld everything in & start your roll cage.After this, weld up the mid-frame & begin roll cage installation. 61'