b'GR7 TRACK-WARRIORTorrington Style Needle BearingsPair for Rear: oCaged Needle Bearing AssembliesoRide Between Two Stainless Steel Races oGo Under Springs to Completely Eliminate Spring Bind oAllows the Springs to Operate at Their True Rate Throughout TravelOptional - Take-Up Springs & DividersPair for Rear:o25# Flat Hypercoil Take-Up SpringsOptionalo6061-T6 Aluminum Divider Sleeves oProtects Threads & Bodies of Rear Shocks When Running Stiff Rear Spring Strategy 3-Piece Splined Rear Sway Bar Kit:o1.75 DOM Tube Mounts Integral in the Track-Warrior Rear Frame Rails o4140 Chromoly 1 OD, Hollow / Wall Thickness & Rates Tailored to Your ApplicationoDelrin Bushings with Optimum Clearance for Response & Non-Bind o6061-T6 Billet Aluminum Sway Bar Arms with 4 Tuning Holes for Fine Tuning oSway Bar Arms Run Outside of Frame & Forward Over the Rear Axle oLong Links Drop Down from Arms to Brackets Welded on Front of Axle Tubes o7075 Aluminum Wide Body Rod Ends, 12-Point 170KSIFasteners, AN Washers & Nylocks TRACK-PRO 9" Ford MOD-LITE Floater Rear End:oMod-Lite Floater Rear Ends Have Been Utilized in Race Cars for Years.oThey are the Key for Safety & Zero Brake Knock-Back! oThe Mod-Lite Floater is Lighter, Medium-Duty Compared to the Grand National o3 OD x .188 DOM Tubes with Vent Hole, Filler Cap & Drain Plug Welded In oMod-Lite ALUMINUM Floater Hubs & 1.811 ID Dual Tapered Bearings oRear Suspension & Brake Brackets Professionally Welded On oSteel Drive Plates 5 x 5.00 / 5/8-18 Wheel Studs oInner Axle Seals Included to Help Contain Gear Oil & Reduce Gear Oil LeaksoOil Cooler Inlet & Outlet Ports Optional Ask Ron AboutHub Upgrade Options 69'