b'GR7 TRACK-WARRIORSweet Road Racing Rack & Pinion / Std Cylinder:oRacing Rack & Pinion with All the Great Sweet Features oStudded Ends Allow Optimum Bump Steer Curve While Keeping Rack Mounted Low oSteering Rates Available from Steady 1.88 to Lightning Quick 4.40 oWe Utilize 2.50 Standard for Track Day Cars & Road Racing oIntegral (But Changeable) Servo with .210 Torsion Bar for Medium Firmness Feel oSofter & Stiffer Torsion Bars Available When Ordering at No Additional Charge oStandard Dual Power Cylinder - Built to Handle Up to 12.5 Front Slicks TRACK-PRO-15 Quik-Tune Tie Rod Package: oThick Wall .156 DOM Tie Rod Tubes / Direct Threaded oChromoly High-Angle Inner & Outer Tie Rod Ends w/Teflon Liners Allow 22 of Angle! o170,000 PSI 5/8 Pro Bump Steer System with Full Range of Shims & SpacersoQuick & Easy Bump Steering Tuning, as Well as Toe-Out Setting Changes FYI: As a student of the Caroll Smith books as a young race car builder, Ron Sutton learned to treat each hardware choice with a lot of thought & key knowledge. No Grade 5 (120 KSI) nuts, bolts or washers are utilized in any RSRT products. Frankly, we use very little grade 8 (150 KSI) hardware. RSRT utilizes 95% 12-point specialty racing bolts rated for 170KSI or AN Aircraft grade. Occasionally, Grade 8 Nuts or Bolts are the only option. That is the other 5%.Some of the Brands we sell do not always have the same high standards of hardware. You will see some grade 5 & grade 8 hardware in Non-RSRT products included in our packages. If you want to replace these hardware pieces with higher grade hardware, Ron will refer you to our special source for top quality hardware. Just know it is expensive. 59'