b'GT1 RACE-WARRIOR Torrington Style Needle BearingsPair for Rear: oCaged Needle Bearing AssembliesoRide Between Two Stainless Steel Races oGo Under Springs to Completely Eliminate Spring Bind oAllows the Springs to Operate at Their True Rate Throughout Travel 3-Piece Splined Rear Sway Bar Kit:oFits into the 1.75 4130 Tube Mounted Integral in the Race-Warrior Rear Frame Clip o4140 Chromoly 1 OD, Gun-Drilled, Step-Down Sway Bar for Lighter WeightoDelrin Bushings with Optimum Clearance for Response & Non-Bind o6061-T6 Billet Aluminum Sway Bar Arms with 4 Tuning Holes for Fine Tuning oSway Bar Arms Run Outside of Frame & Forward Over the Rear Axle oLong Links Drop Down from Arms to Brackets Welded on Front of Axle Tubes o7075 Aluminum Wide Body Rod Ends, 170KSI 12-Point Hardware, AN Washers & Nylocks Race-Warrior CAMBERED Floater Race Rear End with Centerlock Hubs:oHD Ford SVO Racing Housing / 3 OD x .250 4130 Chromoly Tubes / Fixture Weldedo-1 CAMBERED Snouts & Crown Splined Axles = MORE REAR GRIP!oOptimum Secret Recipe Heat Treat, Hardened, Hy-Tuff Racing AxlesProven Strongest o934 1-Nut Race Hub/Drive Plates Bolt to Lightened Grand National Hubs oDRP REM Polished Timken Bearings & Races, Load Spacers, Inner & Outer Seals oRear Suspension & Brake Brackets Professionally Welded On oOil Cooler Ports, Vent, Fill & Drain Plugs Welded In / 934 Centerlock Nuts Included177'