b'Steering Racks for Road RacingOrders: 1-888-STEER-USTech support: 1-307-472-0550Fax: 1-307-235-1551e-mail: tech@woodwardsteering.comType CF Power Racks (ratios from 1.57 through 3.14 inches per turn)Power steering with integral cylinder and servo, for all types of race cars The Woodward CF series is the revolutionary answer for racing applications where packaging restrictions have traditionally dictated a reliance on power racks of the passenger-car type, with their limited potential for performance at the level required in professionally built race cars. A pure racing design based on our more than 30 years experience and manufactured entirely in our own plant, the CF group constitutes the broadest selec-tion of racing power steering racks offered anywhere in the world.The CF design platform encompasses three pinion angles and seven gear ratios. All these are available in both left and right hand drive, and in both front steer (rack ahead behind of the front wheels) and rear steer (rack the front wheels). All utilize the high-capacity, hyper-responsive Woodward servovalve, proven for decades in winning cars all over the world from Eldora to Le Mans. CF power racks are built in custom lengths to match your chassis geometry. Two examples of the CF series, CF20R (top) and CF20S (bottom):CF20R RIGHT HAND DRIVE front steer, pinion angled20 degrees and located INBOARD of the right side mounting bracket. The inboard pinion layout allows the widest mounting base relative to overall rack length and is preferred for racing applications. CF20S LEFT HAND DRIVE front steer, pinion angled20 degrees and located OUTBOARD of the left side mounting bracket. Typical of current automotive practice, this layout offsets the pinion and steering shaft one inch (25 mm) closer to the end of the rack for tight packaging situations. Custom rack lengthRacks in the CF series can be built in any length from 24 inch centers (610 mm) and up; racks shorter than this will have correspondingly shorter travel.Huge choice of steering ratiosEach model in the CF series can be machined for one of seven pinions, to provide a wide choice of steering ratios. Expressed in inches (mm) per turn, these are: 1.57 (40), 1.83 (46,5), 2.09 (53), 2.36 (60), 2.62 (67), 2.88 (73), and 3.14 (80). The entire range of pinions is available in 20 degree, 12 degree and straight, in both left and right hand. 49'