b'FORD AUTOX-PROWeld-On Front Sway Bar Kit 3-Piece Splined o1.25 Splined 4130 Chromoly Sway Bar / Rate Optimized by Ron Sutton for Your CaroPre-Bent, Heat Treated, Steel Sway Bar Arms w/Two Holes 11% Apart Provides 3 Rates oSoftest Rate for Tight AX Courses / Mid-Rate for Avg AX Courses / Stiffest Rate for Road Courses o1.75 Round Crossmember Holds Sway Bar & Adds Chassis RigidityoLaser Cut Angled Struts Reduce Fab Work & Install Time oDelrin Sway Bar Bushings for Low Resistance & Long LifeHotchkis Heavy Duty Road Race CrossmemberoHeavy Duty Thick Wall DOM Tubing / MIG Welded oTrick Slant Top Bosses Provide Easy Access & Optimum Strength oThis Crossmember Ties the Frame & Lower Control Arm Mounts Together oEliminates Flex Under the Hard G-Force Loads Created by the Grip of This Suspension oKeeps the Geometry True & the Handling ConsistentoSlotted to Allow Full Adjustment on Lower Control Arms Newer Version LCA Buckets Recommended for Older Ford Cars, But NOT IncludedoMost Ford Cars 1966/67 & Up Have a Newer Style of Lower Control Arm Mounts with Slots & Eccentrics. The LCA Pivots are Farther Inward Than Older Models.oThis Allows Us to Run Longer Lower Control Arms, Have Better Geometry, Better Bump Steer & Better Camber Gain. If Your Car is Older, You Will Want to Buy A New Set. oCJ Pony Parts Sells New Lower Mounts (#3631X & 3631W) that can be welded onto ALL Older Fords for Around $250 a pair. Please Call CJ Pony Parts Direct at 800-888-6473 FYI: As a student of the Caroll Smith books as a young race car builder, Ron Sutton learned to treat each hardware choice with a lot of thought & key knowledge. No Grade 5 (120 KSI) nuts, bolts or washers are utilized in any RSRT products. Frankly, we use very little grade 8 (150 KSI) hardware.RSRT utilizes 95% 12-point specialty racing bolts rated for 170KSI or AN Aircraft grade. Occasionally, Grade 8 Nuts or Bolts are the only option. That is the other 5%. RSRT does NOT say Vendors Brands we sell, like Detroit Speed, Ridetech, Speedtech & Hotchkis have the same high standards of hardware. You will see some grade 5 & grade 8 hardware in Non-RSRT products included in our packages. If you want to replace these hardware pieces with higher grade hardware, Ron will refer you to our special source for top quality hardware. Just know it is expensive. 402'