377 Chassis Setup & Measuring Tools Wheel Stands Measure, inspect and/or adjust the suspension on your race car while it sits on its wheels. You can string a plumb, measure angles and make adjustments while it’s sitting on its springs. Made out of 1/8" thick aluminum and tested to 3500# each. Set of 4. RST #9699-4 $399.99 Hub Stands Place the car at ride height or higher & work around your front suspension or rear end without the tires & wheels on.  Adjustable height  5 x 5” Bolt Pattern  Can be modified for 5 x 4-3/4” ALL #10664 $87.99 Each Economy Angle Finder Digital Protractor Gauge JOES Digital Level works great to check spoiler, A-arm, pinion, trailing arm angles or whatever else you might need to measure to 1/10th of a degree. The easy to read display has a backlight for night use with an auto shut off to keep the battery fresh. The JOES Level can be user calibrated in seconds. The machined steel leveling surface is wide eliminating distortion that can affect accuracy on models with plastic leveling surfaces. RST #9699-DL $79.95 Small Angle Finder Digital Protractor Gauge Intercomp quality 2” square digital gauge  Locate Angles Digitally / Large LCD Display  Magnetic Base & Sides  Reads from 0°- 90° in 0.05° Increments  Display Rotates 180°  Backlit Display / Standard 9-Volt Battery Operation INT # 102144 $69 Premium Angle Finder Digital Protractor Gauge The Mitutoyo & SPI (Same Gauge) Digital protractors are the quality units I use for car building, checking geometry, doing chassis setups, etc. The economy versions above are fine, but I prefer a more accurate, precision unit. We do NOT sell this gauge. You can get it online from Zoro or Global Industrial around $250. Just wanted to share the best. Tools