217 3-Link Chassis Brackets GT1 Adjustable Curved Slot Lower Link Frame Brackets  For 2” x 2” Square Cross Member or 2” Round Cross Member  Laser Cut 3/16” Thick / 5/8” Slots for Stronger Rod Ends  Includes Curved Cap Straps to Weld On  Slot is curved for proper arc / Doesn’t change wheelbase RST #5350-K - 2” Square Tube (Sample on Left) – Set- $74.99 RST #5351-K - 2” Round Tube (Sample on Right) – Set- $74.99 These brackets below can be used for Lower Link Chassis Mounts, Top Link Chassis Mounts, as well as Accel and/or Decel Link Mounts Bracket A  Special extra long suspension bracket to provide room for the Top Link Adjuster Extension Rod (on the next page) to fit between the rod ends the chassis tube. Other photos in the catalog show this clearly.  Laser cut 3/16” Thick / For TA & TT  5/8” Holes for Stronger Rod Ends than 3/4” Holes RST #5340-A 3/4” Holes – 1 Pair $30 Bracket B  Similar to Bracket A, except ... for GT  1/2” Holes specifically for Decoupled 3-Link Shock RST #5340-B 1/2” Holes – 1 Pair $30 Bracket C  Standard length suspension bracket to mount the rod end close to the chassis.  Stamped 3/16” Thick  5/8” Holes for Stronger Rod Ends than 3/4” Holes  We have this bracket in both 5/8” or ¾” hole versions RST #5340-C 5/8 Holes - 1 Pair $17.99 RST #5340-D 3/4 Holes - 1 Pair $17.99 Bracket 1 – Decel Bracket Box Cap  Works with Brackets A or B  Caps the TOP of 1-3/4” Tube  Has hole for Adjuster rod to pass through RST #5338-1 Caps 1-3/4” Tube $15 Bracket 2 – Decel Bracket Box Cap  Same as above  Fits AROUND of 1-3/4” Tube  Has hole for Adjuster rod to pass through RST #5339-1 Butts 1-3/4” Tube $15 A B C 1 2 1 2 Suspension Components A B C